Never waste time searching for a misplaced nailer or stapler again!
Our 3D-printed Holder offers a convenient way to keep track of your nailers and staplers on and off the jobsite. Designed to be as low-profile as possible, these AirTag mounts sit flush against the body of the tool and make it easy to set and forget! We have found a lot of contractors and DIY-ers like the peace-of-mind that an AirTag can offer.
- All yellow
- All black
- Yellow base / black lid
- Black base / yellow lid
Compatibility: Most DeWalt 20V nailers and, impact drivers. The following tools are compatible with this mount:
- DCN681 Dewalt 20V MAX XR 18 GA Cordless Narrow Crown Stapler
- DCN680 Dewalt 20V MAX XR 18 GA Cordless Brad Nailer
- DCN662 Dewalt 20V MAX XR 16 GA Cordless Straight Finish Nailer
- DCN660 Dewalt 20V MAX XR 16 GA Cordless Angled Finish Nailer
- This may work with other tools that have a similar shape and format but cannot guarantee fit.
--- IMPORTANT ----
This is a 3D printed item so it will be made of plastic. We provide a non-OEM self-tapping screw to fasten this to the tool. We highly recommend using the OEM screw from the the belt hanger/clip instead of the provided screw.
Shipping time can vary but expect your order to ship within 1-3 business days due to current volume.
Works with most DeWalt drills and impact drivers.
No need to modify your drill — it works with the existing form factor. The base aligns to the bottom of the handle and fastens through the accessory hole that's already there.
- 01 Pre-aligned "teeth" on the back seat the base in the right position.
- 02 A single screw through the accessory hole locks the base to the handle.
- 03 A two-screw lid traps the AirTag so it can't shake loose on the job.
A low-profile way to add Find My tracking to the drill you reach for every day — in stealth black, sunshine yellow, or two-tone.
Pick your colorway.
Same holder, four finishes — go stealth, go loud, or mix the lid and base.
One screwdriver, three steps.
No setup, no guesswork — the base lines up to the handle on its own and fastens through the hole that's already there.
Set the base at the bottom of the handle so its hole lines up with the existing accessory hole. The teeth on the back pre-align it for you.
Once the base is screwed to the drill or impact driver, set the AirTag into the pocket. That's it — just drop it in.
Put the lid on and secure it with the two screws. Super simple — and your AirTag is locked in for good.