Never waste time searching for a misplaced drill again. Our 3D-printed holder is a clean way to pair a DeWalt drill with an Apple AirTag — it bolts to the handle using the accessory hole that's already there, so there's nothing to modify.
It fits most DeWalt drills and impact drivers, comes in four finishes, and makes a great gift for the person who already has every tool. Drop an AirTag in, snap the lid on, and your drill is on Find My.
Works with most DeWalt drills and impact drivers.
No need to modify your drill — it works with the existing form factor. The base aligns to the bottom of the handle and fastens through the accessory hole that's already there.
- 01 Pre-aligned "teeth" on the back seat the base in the right position.
- 02 A single screw through the accessory hole locks the base to the handle.
- 03 A two-screw lid traps the AirTag so it can't shake loose on the job.
A low-profile way to add Find My tracking to the drill you reach for every day — in stealth black, sunshine yellow, or two-tone.
Pick your colorway.
Same holder, four finishes — go stealth, go loud, or mix the lid and base.
One screwdriver, three steps.
No setup, no guesswork — the base lines up to the handle on its own and fastens through the hole that's already there.
Set the base at the bottom of the handle so its hole lines up with the existing accessory hole. The teeth on the back pre-align it for you.
Once the base is screwed to the drill or impact driver, set the AirTag into the pocket. That's it — just drop it in.
Put the lid on and secure it with the two screws. Super simple — and your AirTag is locked in for good.